Rack and pinion bushing set TOYOTA TACOMA INSTALLATION INSTRUCTIONS

0

Filed Under (Toyota) by admin on 03-04-2012

Download
Rack and pinion bushing set TOYOTA TACOMA INSTALLATION INSTRUCTIONS
1.) Lock steering wheel to prevent it from rotating, before loosening any fasteners. Raise front of vehicle and support properly, allowing easy access to steering rack location. 2.) Remove rack attaching bolts, tie-rod end from driver side steering knuckle, and remove rubber bushings. 3.) Install new bushings and sleeves as shown in diagram. Note: 1 3/4″ flat washer must be installed between driver side rack bushing and vehicle crossmember. 4.) Position steering rack for installation, being sure not to damage bushings. Install “U” bracket over the “D” shaped bushing on passenger side rack mount. Begin tightening the fastener on the driver side location and the fasteners on the passenger side location until the sleeve in the center mount location aligns with the mounting holes in the crossmember.

Incoming search terms:

steering wheel hang bushing for toyota tacoma,1998 tacoma rack and pinion,how to replace bushings on rack and pinion toyota tundra,rack and pinion repair 2001 tacoma,replacing 1997 toyota 4 runner rack and pinion,schematic of a rack and pinon for a 2005 toyota camry,signs of bad rack & pinion Toyota tacoma,steering rack installion on 2005toyota tundra,step by step directions to replace a rack and pinion for 1999 honda civic,tacoma rack bushing kit,toyotatacoma 1997 how to replace bushings,what does it cost to change a evaporator core in 1997 tacoma,Flat rate to install rack and pinion on a 2003 toyota tacoma,changing rack and pinion on lifted tacoma,1999 4runner rack and pinion bushing remove and replace,1999 forerunner steering gear removal,2000 camry rack pinion manual,2000 sienna rack pinion bushing,2000 sienna rack pinion bushing diagram,2001 tundra steering bushing replace directions,2002 tundra rack replacement how to,2003 Toyota Tacoma trd pre runner rack and pinion removal,2010 toyota tundra replacement instruction rack and pinion,4runner rack & pinion inlet removal,changing belts on toyota tacoma,will a 99 tacoma rack a pinion fit a 2000 tundra